Columbia Woodworkers Club

Cutting coves on the tablesaw Add Video

Mark Barr explains how to cut a cove using the tablesaw and a very simple jig.

Posted by Ken Thayer on May 22, 2010 at 5:13 PM 2974 Views

Post a Comment


Oops, you forgot something.


The words you entered did not match the given text. Please try again.

Already a member? Sign In


Reply Nick
1:40 PM on May 27, 2010 
Thanks Ken. Takes about 5 minutes to load video at 750K connection (RR lite). Worth the time to see how simple coves on table saw are. A web site for calculations on coves is Note the way Mark installed the guide. The angle shown lets the force of the cut towards the guide not away from it, as when installed the other angle direction. The best thing is to put a traping guide (trough) of 2 boards as Mark stated at the end of his demo. Use push sticks for safety. A feather board on top helps with consistency if doing multiple moldings. If I can find it, I will post a picture of a molding for a set of shelves I made a few years ago.
Reply Nick
9:50 PM on May 24, 2010 
Could not get the video to show waited 5 minutes+ to load. No luck.

Recent Forum Posts

by Ken Thayer over a year ago
by Ken Thayer over a year ago
by Ken Thayer over a year ago

Upcoming Events

No upcoming events

Recent Videos

2968 views - 2 comments